Lexus RC350 & RCF Forum banner
1 - 13 of 13 Posts

·
Registered
Joined
·
126 Posts
Are you referring to one for the whole front end? Because I just got mine on 6/6/2015 and it came with clear film across the front of the hood, front ends of the front fenders and across the top of the rear bumper. I apologize if I'm misunderstanding you...
 

·
Premium Member
Joined
·
310 Posts
Are you referring to one for the whole front end? Because I just got mine on 6/6/2015 and it came with clear film across the front of the hood, front ends of the front fenders and across the top of the rear bumper. I apologize if I'm misunderstanding you...

I think the OP is referring to the front end car bra that the end user can put on and take off at will. Like this example: Car Bras & Car Mask - Custom Front End Hood Protection | AutoAnything


You and I have the one that a Pro puts on and it stays on.
 

·
Registered
Joined
·
47 Posts
I had eXpel put on my RC, although I got my car so early I had to wait until the company got its hands on one in order to make the templates. I had the hood, front fenders and mirrors done (and for a few bucks more, the "luggage shelf" which is the top of the back bumper). The pieces are designed and cut so well it is almost impossible to see the edges even when looking for them.
As for the grille, my installer said he would look at what could be done, but he was unable to do anything with the grille itself, even the horizontal bar. He did do the headlights, of course, as well as the L logo in the center of the grille.
 

·
Premium Member
Joined
·
310 Posts
I had assumes that the actual grille would be left alone as it would be near impossible to wrap it in clear armor.

I too had asked my EXPEL installer if anything could be done for the front grille and he said it was impossible to wrap the grille. I just try to stay far enough back from vehicles that if something is kicked up I have time to move.
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top