Lexus RC350 & RCF Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Thinking seriously about installing a Tanabe strut bar in my new RC350 FSport- only install thing I am concerned about is the fact that both dust covers over the suspension towers must be permanently removed for the life of the install.

Any feedback from members that might advise against such a removal?
 

·
Premium Member
Joined
·
310 Posts
Thinking seriously about installing a Tanabe strut bar in my new RC350 FSport- only install thing I am concerned about is the fact that both dust covers over the suspension towers must be permanently removed for the life of the install.

Any feedback from members that might advise against such a removal?
A member in another Lexus forum installed this and said the units are sealed. Here is his install pic.

 

·
Premium Member
Joined
·
310 Posts
The units are sealed but the connector is not. What I just did is put Black silicone RTV at the back side of each connector to seal off the side that would be normally exposed. Once the connector is inserted then it will become somewhat water tight.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top